Shop

You may process vegetables, lettuce, cabbage, bread, fried food, dried fruit, berries, fruit, eggs with or without shell, poultry, thin chicken bones, meat, coffee grounds, tea leaves, paper tea bags, fish, nuts, biodegradable plates and food waste. For the best result, it is important to always use mixed food waste.

Do not place non-food materials such as stones, metal, glass or plastic in the appliance. Large bones, cardboard, paper, hard objects, living animals, insects, pits from nectarines, peaches, avocados, mangos and plums, shells, sweets, chewing gum, oil, grease, liquids and alcohol are also not suitable.

Open the lid using the security lock and remove the container from the appliance. Fill the container with kitchen waste, but never above the maximum indication. Do not press the waste down. Then place the container back correctly, making sure that the arrow on the container is opposite the arrow on the appliance.

Plug the appliance into an earthed socket. The display will turn on automatically. Press the button once for Fast Mode, twice for Standard Mode and three times for Self-Cleaning Mode. Then press and hold the button for 3 seconds to start the selected programme.

Yes. During operation, you can press the button to pause the appliance. Press the same button again to restart it. Never open the appliance during operation without pausing it first.

When processing is complete, you will hear a beep. Wait 15 to 20 minutes before removing the container, as it may be very hot. After the first cycle, it is best to always leave a little mulch in the container. This helps to achieve a better result in the next cycles.

Always use a mix of different types of food waste and avoid filling the container with only one type of waste. Do not overfill the container, do not press the waste down and leave a little mulch in the container after the first cycle. This helps The Mini Mulch 2.0 work optimally.

Use Self-Cleaning Mode to clean the container. Make sure the appliance is switched off, fill the container with 2/5 water, select Self-Cleaning Mode and press the button for 3 seconds. The container can also be removed from the appliance and rinsed under running water. Only place it back once it is completely dry. Clean the housing only with a damp cloth.

When all LED lights come on, it is time to replace the activated carbon or the entire filter. After replacement, press and hold the on/off button for 10 seconds to reset the signal.

Flashing LED lights indicate a malfunction. LED 1 flashes when the appliance was opened during operation. LED 2 flashes when the motor is jammed. LED 3 flashes when the fan is jammed. LED 1 and 2 flash when the temperature is too high. All LEDs flash when the activated carbon filter must be replaced.

Do not continue using the appliance in case of a malfunction. Pause or switch off the appliance, unplug it if necessary and check the possible cause, such as a blocked blade, blocked ventilation, excessive temperature or a carbon filter that needs replacing. If the malfunction is not resolved, contact your point of purchase.

Press and hold the button for 10 seconds to reset the appliance if necessary.

Place the appliance on a heat-resistant, solid and flat surface, such as a kitchen worktop or table. Leave at least 15 cm of free space between the rear of the appliance and the wall or other objects, so ventilation is not obstructed. Never use the appliance outdoors.