Shop

The Turbo SF fryer features a heating element on 2 levels. This allows faster heating, lower energy consumption and crispier frying results.

Yes. FRITEL recommends frying oil. When using solid frying fat, cut it into small pieces and spread them evenly over the entire heating element. Then use the melting position until all the fat has completely melted. Never place the fat in the frying basket.

The reset button pops out when the safety thermostat detects overheating. Let the fryer cool down completely before pressing the reset button again.

Check whether the bowl is correctly installed, the control panel is properly mounted on the sliders and whether the reset button has popped out. Storing the fryer in a very cold place may also activate the safety thermostat.

Always remove excess ice from frozen food and avoid water accumulation in the bowl. Never hang a basket with frozen food above oil that has not yet reached 130 °C.

Use potatoes with sufficient starch content, dry the fries well and fry at the correct temperature. For fresh fries, pre-fry at 150-170 °C and finish frying at 180-190 °C.

No. Aggressive dishwasher detergents may cause rust. Clean the basket in warm soapy water using a washing-up brush.

Replace the oil when it becomes old or contaminated. As a guideline, this is after about 10 frying sessions, depending on the food being prepared.

No. The fryer must never be heated without oil or with too little oil, as this may permanently damage the appliance.

Yes, but only if your Turbo SF is equipped with a filter lid. If your fryer only has a dust lid, you must never fry with the lid on the appliance

The reset button is a small red button located at the back of the control unit. If the overheating protection has been activated, you can press it again after the appliance has cooled down to reset the fryer.

The slide bracket is the support on which the control unit is mounted. If the control unit is not properly fitted onto the bracket, no electrical contact is made and the fryer will not operate. Always position the control unit correctly until you hear a clear click.

A blue-grey discoloration of the heating element usually indicates overheating. This can occur when the fryer was heated without oil, with insufficient oil, or when solid fat was not melted according to the instructions.

First try pressing the reset button after the fryer has completely cooled down. If the fryer still does not work afterwards, the complete electrical control panel must be replaced. This type of damage is considered user-related and is not covered by warranty.

The legal warranty period is 2 years from the date of purchase. By registering the appliance at www.fritel.com, the warranty can be extended to 10 years, subject to the applicable conditions.

The additional 8-year warranty applies only to the heating element.

For purchases made in the name of a company with a valid VAT number, consumer legislation does not apply. In that case, a 1-year warranty applies from the date of purchase.